View Full Version : Looking to start engraving
MKETOOL
02-02-2010, 01:27 PM
I am currently looking to get into engraving guns, but I don't really want to spend the money on a new engraver if it turns out I am not good at it. I am pretty artistic and good with my hands, so I think I can learn. My question is, does anyone have a used airgraver they may want to sell. You can email me at timg1@att.net Thank you, Tim
K Frei
03-24-2010, 07:39 AM
hello. i would have to say to you that on this webe site if you go down to the bottom of the page and on the right side there is a forum jump. of you then scroll to engraving forum there is a note there on an inexpencive way to give it a try.
IUinvictus
04-11-2010, 08:46 AM
you can make this for 6$ and it works pretty well to see if your any good. I just screwed a piece of steel to a work bench and used an old tac hammer. its a lot of fun.
vBulletin® v3.8.6, Copyright ©2000-2024, Jelsoft Enterprises Ltd.