Victor Lederman
04-29-2010, 02:45 AM
Hi everybody
I am new to this forum. I am retired goldsmith with a basic knowledge
of push-engraving. I am a knifemaker too and want to learn engraving on steel. I have a GRS system3 which I used to close bezels on cabochone
settings.I understand that this device is too crude for engraving and
I am considering buying Artisan Airgraver.Question : the foot-control
of system3 could it be used with the Artisan ?.I 'll be very grateful
of your advice. Victor
I am new to this forum. I am retired goldsmith with a basic knowledge
of push-engraving. I am a knifemaker too and want to learn engraving on steel. I have a GRS system3 which I used to close bezels on cabochone
settings.I understand that this device is too crude for engraving and
I am considering buying Artisan Airgraver.Question : the foot-control
of system3 could it be used with the Artisan ?.I 'll be very grateful
of your advice. Victor