some of the stuff i´ve made

[praktis]

Hi everyone,
i didn´t know where to put this but i think here will do nicely..

me i´m a knifemaker and gunsmith
here are a few things i´ve made

http://img.photobucket.com/albums/v386/praktis/twistdamasteel2.jpg

http://img.photobucket.com/albums/v386/praktis/snakewooddamasteel2-1.jpg

http://img.photobucket.com/albums/v386/praktis/snakewooddamasteel1-1.jpg

http://img.photobucket.com/albums/v386/praktis/boxelderdamasteel2.jpg

http://img.photobucket.com/albums/v386/praktis/boxelderdamasteel1.jpg

http://img.photobucket.com/albums/v386/praktis/hot1.jpg

http://img.photobucket.com/albums/v386/praktis/praktis133316.jpg

http://img.photobucket.com/albums/v386/praktis/praktis133308.jpg

/Roger

[Jörmungandr]

Nice to see you here Roger!

[Daniel Houwer]

i didn´t know where to put this
Well I do!
Post it here,
http://www.handengravingforum.com/newthread.php?do=newthread&f=2
If all is good It would show on the main forum on this site.
Your knife work is outstanding!
I would like to know if you sell your blades with or without bolsters.
Heck, they are too beautifull by them selves to engrave.
They dont need adornement.
Do you make knifes with bolsters? And what would they cost?
I might be looking for a project to engrave.

Welcome here by the way!
Your work is apreciated :yo[1]:

[JasonH]

Praktis, Beautiful Work! i really like the double rifle:thumb[1]: Ive been throwing around the idea of making a new set of barrels for an old double shotgun that i acquired a few years ago. Did you make the barrels for your gun? I haven't been able to find a gunsmith yet that would give me any advice on alignment and soldering of a double rifle set up! i guess nobody really wants to fool with it any more. any tips or at least a direction to go would be appreciated.