Thread: flat gravers
View Single Post
  #3  
Old 07-30-2016, 03:11 PM
Tscott Tscott is offline
Copper
 
Join Date: Apr 2016
Location: San Antonio
Posts: 4
Default Re: flat gravers

Good afternoon-

I have the flat/knife template bench stones and drill press 220 lap. My first set of templates came with basic instructions and a sharpened graver. Thus I had an idea what it was suppose to look like and an idea of how to get there.

I'm not sure how to get started with the flat template. I am assuming with the small green four sided template. What's next. The bottom? then the sides? how much do I take off? Any help would be appreciated. I'm sure it will be obvious once I understand better.

I have researched extensively and find some good you tube video on the basic template. And search the forum for conversations on sharping flats but no luck. Perhaps to basic

Thanks
Reply With Quote