View Single Post
  #2  
Old 04-05-2011, 01:08 PM
zota zota is offline
Steel
 
Join Date: Oct 2009
Location: Ploiesti .Ro
Posts: 77
Default Re: coining (wasnt sure where this would go)

I did not trust such pressure because you can not have them cotrolul.Rather look for a manual screw press (if that depth are small details).Why I did not understand is how to beat a coin in a 22mm diameter 17mm diameter mold.I like everyone, I think, using blanks smaller diameter up to 1.5mm from the depths of engraving mold 2-2.5mm but using a friction press of 1500t.If you're a beginner asks for help from someone who has done that and not play with your health.A matrix is worse than a broken shell.Successful and hear only good things
__________________
Ilie
Reply With Quote