View Single Post
  #7  
Old 04-26-2011, 10:17 AM
Steve Lindsay's Avatar
Steve Lindsay Steve Lindsay is offline
Administrator
 
Join Date: Feb 2006
Location: Kearney, NE
Posts: 4,552
Default Re: PalmControl photos

Hi Tom, Yes, it is a lock release. It is more like a wedge setup in it. The lock bar slides back and forth. The release button rolls to move the slide bar. It comes apart. Here is a photo of it disassembled. There are no holes drilled from the outside of the knife. It has blind T slots little holders with three 0-80 screws that come in from the side of the T slot that has a taper on it so that it pulls the two halves together. The set screws are accessed by reaching in from the bottom (into the blade opening). One side of the knife handle and the center portion of the knife (the back block, top block and blade bushing) are milled from one block and are one piece.



__________________
__________________________________
Steve Lindsay
AirGraver.com
EngravingArtist.com
Reply With Quote