View Single Post
  #12  
Old 06-12-2007, 07:56 PM
Jon C. Dake's Avatar
Jon C. Dake Jon C. Dake is offline
Steel
 
Join Date: Apr 2006
Posts: 54
Default Re: An Engraving Puzzle

Well I went out to the shop today and played some with the inlay. I must say that even though I saw what you did, I was a little skeptical that the two metals would provide a clean line. I was pleasantly surprised at how clean and crisp the lines were where the two metals (copper and silver) came together. I had been wondering for some time how that was done and now I know. My practice plate even passed the "drop it on the floor and see if it pops out" test. Thanks much for this helpful thread. Jon

Last edited by Jon C. Dake; 06-12-2007 at 08:03 PM.
Reply With Quote