View Single Post
  #4  
Old 05-17-2014, 10:38 PM
Steve Lindsay's Avatar
Steve Lindsay Steve Lindsay is offline
Administrator
 
Join Date: Feb 2006
Location: Kearney, NE
Posts: 4,552
Default Re: Three new products. Gravers and templates

Negative relief template with the Universal 116 degree point.




Below photo is from one of the original patent drawings that is at the bottom of the sharpener instructions page. It shows this type of point well. http://www.engravingschool.com/priva...0Sharpener.htm



Negative relief 116 Uniform-Parallel graver template.

This template is the same as the normal 116°, but the relief grind under the heel is negative. The purpose of this negative grind is to achieve more heel clearance. This additional relief was described in the
Lindsay Uniform-Parallel patent, but this is the first template made available to actually achieve this point.

This template requires that the height of the grinding lap or bench stone be 3/4" instead of the usual 1/2" seen in all previous templates. I recommend just shimming your 1/2" stones up the last 1/4". The plastic 6"x6" plate included with the full sharpening kit happens to be 1/4", so that can utilized.

A power hone for initially shaping this is helpful. However it can be done with the diamond bench stones. Steve tested how long it would take him to sharpen one from a carbalt blank on the diamond bench stones. It was 15 minutes. Of course starting with a the 3 degree tapered carbalt blank would considerably shorten the time.
$27.00

__________________
__________________________________
Steve Lindsay
AirGraver.com
EngravingArtist.com
Reply With Quote