Engraving Forum.com - The Internet's Largest and Fastest Growing Engraving Community

The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 13,488. Welcome to our newest member, Robertatkinsontattoo
EngravingForum.com - Domain since Feb 7, 2003

Graver Video Conferencing is empty Join now!


Go Back   Engraving Forum.com - The Internet's Largest and Fastest Growing Engraving Community > Forums > Lindsay AirGraver Info - Hand Engraving Forum
ENGRAVING TOOLS - Paypal accepted Classes Glossary Feedback Tips Sharpening Bulino Videos Forum Policies

Reply
 
Thread Tools
  #1  
Old 12-25-2016, 09:14 AM
Lisandros Lisandros is offline
Steel
 
Join Date: Feb 2014
Location: Argentina
Posts: 10
Default Draw and engraver

Hi,I wanted to ask, how should I face the drawing and later engraving on a cylinder cone 44mm long and cone of 12mm ...and 16mm, thanks
Reply With Quote
  #2  
Old 12-25-2016, 07:32 PM
Sam Welch's Avatar
Sam Welch Sam Welch is offline
Platinum
 
Join Date: Jun 2006
Posts: 542
Default Re: Draw and engraver

I would make a paper pattern wrapped around the cone then flatten out the paper and draw my design on the paper...make a transfer from the pattern and place on the cone for engraving. I assume the 12 and 16 mm dimensions are diameters of the ends of the cone.

PS...that would be about the size of a 1 and 3/4 inch section of a rifle barrel near the muzzle. But more taper.
__________________
Sam Welch A.I.E.

Guns, guitars and old cars
Reply With Quote
  #3  
Old 12-27-2016, 05:30 PM
Lisandros Lisandros is offline
Steel
 
Join Date: Feb 2014
Location: Argentina
Posts: 10
Default Re: Draw and engraver

Yes , thank you very much.
Reply With Quote
Reply

Bookmarks

Thread Tools

Posting Conduct
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -6. The time now is 03:44 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.