Engraving Forum.com - The Internet's Largest and Fastest Growing Engraving Community

The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,732. Welcome to our newest member, Miss Allison
EngravingForum.com - Domain since Feb 7, 2003

Graver Video Conferencing is empty Join now!


Go Back   Engraving Forum.com - The Internet's Largest and Fastest Growing Engraving Community > Forums > Who's Who - Hand Engraving Forum
ENGRAVING TOOLS - Paypal accepted Classes Glossary Feedback Tips Sharpening Bulino Videos Forum Policies

Reply
 
Thread Tools
  #1  
Old 02-17-2009, 01:57 PM
slipped slipped is offline
Copper
 
Join Date: Feb 2009
Posts: 5
Default hello

hi every one i am new it all looks great
i am a silversmith with no graving exp at all!
i am setting up some practice plates of brass. should the brass be hard
or soft my gravers are the boxed set from rio grande efb gravers with
the funky handles .
any one use them?
Reply With Quote
  #2  
Old 02-17-2009, 02:24 PM
Tom McArdle's Avatar
Tom McArdle Tom McArdle is offline
Platinum
 
Join Date: Apr 2006
Location: Western NY USA
Posts: 1,040
Default Re: hello

Welcome! I went the opposite route, I was an engraver first, the became a bit of a silversmith for a little while...

I believe you will find copper to be much more similar to silver as far as how it cuts. You may have some problems with the brass sticking to the graver after you cut a while, and this will make your cutting more difficult. This can happen with gold also, especially when using carbon steel tools. I saw a tip in Rio Grande's catalog years ago that recommended carbide tools for precious metal engraving, as the carbide resisted the gold's tendency to stick to the tool better than the carbon steel tools did.

It is important to have a way to view your tool points at a high level of magnification, so a microscope or a powerful loupe will help a lot. defects in the point of a tool that you can't see with the naked eye will often cause you much trouble when trying to engrave, and this may cause unnecessary frustration as you try to learn. Always check the tool, when you have any difficulty in cutting...

The only drawback with the carbide tools is that you need diamond stones to sharpen them. If you can afford it, an investment in Steve's tool sharpening templates and stones will be a great help as you get started. It is challenging enough without extra tool problems due to sharpening issues.

take care,

Tom
__________________
Tom McArdle
Reply With Quote
  #3  
Old 02-17-2009, 05:12 PM
carl bleile's Avatar
carl bleile carl bleile is offline
Platinum
 
Join Date: Mar 2008
Location: cincinnati,ohio
Posts: 380
Default Re: hello

Welcome, the first and most important thing to do is learn how to sharpen your tools, I have never seen a set of tools that have been presharpened correctly, and being new to engraving you will dull or break the points frequently. For a look at what tools should be ground like go over to Lindsays tool site he has pictures of tools and their uses.
Carl Bleile
southwest,Ohio
Reply With Quote
Reply

Bookmarks

Thread Tools

Posting Conduct
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -6. The time now is 05:30 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.