|
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 5,201. Welcome to our newest member, graverman1
EngravingForum.com -
Domain since Feb 7, 2003
|
|||||||
| ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
 |
|
|
Thread Tools | Display Modes |
|
#1
03-09-2009, 05:07 AM
|
||||
|
||||
Video ti to use the Roland Baptiste point
I make a little video but sorry for the bad quality.
http://www.youtube.com/watch?v=OyRYD9OjUUU Steps: 1 you cut your line 2 you pass with my point in the two sens into the line. you must have a inclination of your tool, +- 35 to 45° angle 3 you put the gold wire 4 you polish I hope it will be easier for you
__________________
http://rolandbaptiste.com 
|
|
#2
04-22-2010, 03:04 AM
|
|||
|
|||
|
Re: Video ti to use the Roland Baptiste point
Thank you very much.
From Thailand.
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
