The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,761. Welcome to our newest member, Bruno
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
|
Thread Tools |
#1
|
|||
|
|||
Any tips for a better stipple background? Thanks!
A case barlow knife i'm working on. How can i get the stippling to be darker? I cut away the background with a flat graver about .015 deep then stippled with a pointed hss tool with a pyramid shape. Did i not stipple deep enough? I was at 60 psi with the tungsten piston letting it "bounce" so it didnt dog a hole. Once i finished i filled with rustoleum flat black and wiped away with a clean finger. Thanks for any tips! First time trying relief work with stippling.
|
#2
|
||||
|
||||
Re: Any tips for a better stipple background? Thanks!
Hi Mike, Rustoleum does not work well. Not very much pigment in it.
I use two types of black in an engraving. One for deeper cuts and background, and another type for shading and bulino light cuts. There is information about blacks at the bottom of page link: http://engravingschool.com/private/FAQ.htm I haven't been using the hardware store type paints as the ones I tried didn't seem to have a lot pigment to the solvent ratio in them. I use a product that way back used to be called "Background Antique" from the jewelry suppliers. The name of it has changed over years but it seems to be the same stuff. It is a flat black lacquer paint but with a lot of pigment. Paint it over the engraving with a brush, and while it is still wet, quickly wipe off the surface with a paper similar to newspaper. I use this paint in the deeper cuts and background. For fine shading use an oil base printers ink. Smear or dab this into the fine cuts with a finger, then wipe off the surface with the same type of paper. Dab it on carefully so you don't get in on your flat black paint areas. If the metal has a nice polish, wipe only in the direction of the final polish of the piece. Here is a link to an oil based printers ink for shading cuts https://www.dickblick.com/.../cranfield-traditional.../ Here is a link for the black lacquer with good amount of pigment. https://www.riogrande.com/.../midas-...ound.../335400 Here are previous thread on the forum about the paint and inks: http://engravingforum.com/showthread.php?t=10454 http://engravingforum.com/showthread.php?t=11634 http://engravingforum.com/showthread.php?t=11761 http://www.engravingforum.com/showthread.php?t=3150 http://engravingforum.com/showthread.php?t=6398
__________________
__________________________________ Steve Lindsay AirGraver.com EngravingArtist.com |
#3
|
|||
|
|||
Re: Any tips for a better stipple background? Thanks!
Thanks so much for the tips! Your the man!
|
Bookmarks |
Thread Tools | |
|
|